DS1206N BASIC-programmable Board

The DS1206N is a BASIC-programmable board designed primarily for serial-over-IP and serial control applications. Being small enough to fit inside your product, the board offers a rapid development alternative to using modules, which require designing a new host PCB.

Like the DS1206 controller, the DS1206N features a multi-channel serial port. The device has a single serial port connector and is priced as a single-port device, yet packs four independent serial channels. Have no use for those DSR and DTR lines? Turn them into RX and TX of an additional serial channel. Dont want CTS and RTS either? Thats one more channel! In total, there are 15 different configurations to choose from.

The board is supplied in three versions offering various serial port and power options. It comes preloaded with a fully functional serial-over-IP application.

Specifications:

*Three options: DS1206N-RS, DS1206N-TM, and DS1206N-TS
*Superior upgrade to the EM1202EV board
*Based on high-performance purpose-built 88MHz T1000 IC
*10/100BaseT, auto-MDIX Ethernet port.
Up to 3.5 serial channels:
-DS1206N-RS: RS232 port (DB9M connector);
-DS1206N-TM, -TS: TTL serial port (pin header connector);
-Baudrates of up to 921,600bps;
-None/even/odd/mark/space parity modes;
-7/8 bits/character modes;
-Full-duplex mode with optional flow control;
-DS1206N-TM and -TS: half-duplex mode with direction control;
*Flexible mapping with 15 different options, such as:
*A single channel: RX, TX, CTS, RTS, DSR, and DTR lines;
*3.5 channels: RX, TX, RX2, TX2, RX3, TX3, and RX4 lines
*DS1206N-RS: optional 12V power output on DB9M connector;
*DS1206N-TM: optional 12V power input from the serial port
*Up to 1024KB flash memory for firmware, application, and data
*2KB EEPROM for data storage
*Four LEDs:
-Green and red status LEDs on top of the device;
-Link and speed Ethernet status LEDs on the RJ45 jack
-Software-controlled onboard PLL.
*Power:
-DS1206N-RS, -TM: onboard regulator, 10-24V (12V nomial);
-DS1206N-TS: direct 3.3V input (must be regulated to +/- 5%)
*Board dimensions: 52.6x38.0mm.
*Firmware is upgradeable through the serial port or network